Front Door Window Motor: Service and Repair

Window Regulator Motor

Removing

- Door trim removed.

• Motor for window regulator can be removed or installed in every position of motor or side window.

• Before removing motor, disconnect electrical harness connectors.

- Remove Torx bolts - 2 - (T30) and remove motor.





Installing

- When installing, make sure that threaded pins - arrows - are engaged in inner door plate.

- Slide on window regulator motor -1- and secure with bolts - 2 -.

- Tightening torque 3.5 Nm

• Only switch ignition on and off after installing motor and connected wires.

• Then move door window upward to stop and keep pressing switch for window regulator for approx. 2 seconds longer.

• This position is the base position and the high- and low-running function is activated.