Data Bus On Board Diagnostic Interface

Data Bus On Board Diagnostic Interface

Special tools, testers and auxiliary items required

• Protective cap for cable connector (VAS 6223/9) from fiber optic plier repair set (VAS 6223)

Removing

- If the control module was replaced, select the Replace function for the respective control module in Guided Fault Finding or Guided Functions.

- Select the function or path






- Follow the instructions on the Vehicle Diagnosis Tester display.

- Switch off ignition and remove ignition key.

- Remove the glove compartment.

- Remove bolt - 2 -.





- Pivot the data bus on board diagnostic interface (J533) - item 3 - out of the bracket - arrow -.

- Disconnect the electrical connector - 4 -.

- Disconnect the fiber optic cable connector - 1 -.

- Seal open wiring harness fiber optic connector - 2 - with (VAS 6223/9) - item 1 -.





• Protective cap prevents contamination of or mechanical damage to end face of fiber optic cable which would impair signal transmission.

Installing

• Tightening specification, refer to => [ Data Bus On Board Diagnostic Interface Assembly Overview ] Data Bus On Board Diagnostic Interface Assembly Overview.

Install in reverse order of removal, observing the following:

If the data bus on board diagnostic interface was replace, it must be coded again.

- Select the function or path






- Follow the instructions on the Vehicle Diagnosis Tester display.

- Install the glove compartment.