Fuel Level Sensor 1

Fuel Level Sensor 1

Removing

- Remove rear engine cover - top arrows -.





- Free up the fuel hose - 1 - and the EVAP canister hose - 2 - on the air duct pipe.





- Remove vacuum hose - 3 - from the connection on the air guide pipe.

- Remove air guide pipe by loosening the hose clamp - 4 - and opening the clips - arrows -.

- Disconnect electrical connector - 1 -.





- Open the locking mechanisms - arrows - and Secondary Air Injection Sensor 1 (G609) - 2 -.

Installing

Installation is in reverse order of removal, note the following:

• Replace O-ring.

• The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

• Secure all hose connections with hose clamps appropriate for the model.

• In order to be able to securely mount the air guide hoses on their connectors, spray the screws on the previously used clamps with a rust remover.