Left Secondary Air Injection Combination Valve

Left Secondary Air Injection Combination Valve

Removing

• During installation, all cable ties must be re-installed at the same location.

- Pull rear engine cover - arrows - off.





- Drain coolant => [ Cooling System, Draining and Filling ] Cooling System, Draining and Filling.

- Remove left coolant pipe => [ Left Coolant Pipe ] Left Coolant Pipe.

- Remove Heated Oxygen Sensor (HO2S) 2 (G108) (in front of catalytic converter).

- Disconnect air guide hose - 3 - from Secondary Air Injection (AIR) combi-valve.





- Remove bolts - 1 and 2 -.

- Free up electrical wiring and remove secondary air injection (AIR) combi-valve.

• The engine is shown from behind to provide a better illustration.

Installing

• Tightening Specification => [ Secondary Air Injection System Assembly Overview ] Service and Repair.

Installation is in reverse order of removal, note the following:

• Replace seals and O-rings.

• Secure all hose connections using hose clamps appropriate for the model type.

• During installation, all cable ties must be re-installed at the same location.

- Install Heated Oxygen Sensor (HO2S) 2 (G108) (in front of catalytic converter).

- Install left coolant pipe => [ Left Coolant Pipe ] Left Coolant Pipe.

- Place oil dipstick guide tube in hole on upper part of oil pan.

- Fill with coolant => [ Filling ] Cooling System, Draining and Filling.