Removal and Replacement
Lock Carrier with Attachments Overview
If the vehicle has distance regulation (ACC), not the following:
If the lock carrier is removed and re-installed or changes are made to ACC bracket, distance regulation adjustment must be carried out.
1 Bolt
• 30 Nm
• 3 pieces per side.
2 Side Impact Bar
• Secured to the lock carried with the bolt - 3 -.
• Do not remove with the bracket when removing the lock carrier.
3 Bolt
• 4 Nm
• Secures the impact bar to the lock carrier.
4 Lock Carrier
• Drain the coolant before removing.
• Removing
• Removing the lock carrier cover.
- Remove front bumper.
- Disconnect all electrical wires and hoses to the lock carrier at the connection points.
- Disconnect the hood lock cable at the coupling. Refer to => [ Hood Release Cable Overview ] Hood Release Cable Overview.
- Remove the bolts - 5 -.
- Remove the bolts - 1 - on the longitudinal member (quantity: 3 per side).
• The impact absorbers with the brackets are secured to the lock carrier with one bolt each - 1 - and must not be removed.
- Remove the bolts - 6 - on the lower lock carrier.
- Remove the lock carrier with the headlamps forward.
• Installing in reverse order.
• Adjust the headlamps after installing.
5 Bolt
• 10 Nm
6 Bolt
• 1.5 Nm
7 Fenders
Removing lock carrier cover
1 Cover
• To remove, remove the locking pin and release the expanding clip.
• Remove the expanding clip from the cover.
• Remove the cover back from the radiator grille.
• When installing, the tabs on the cover must engage on the radiator grille and on the sides of the bumper cover.
• Insert the expanding clip through the cover into the lock carrier and press the locking pin in.
2 Spreader Clip
• Remove the clamping pin when removing.
• Only press the clamping pin in when installing.
• Quantity: 4
3 Lock Carrier
4 Radiator Grille
Lock Carrier Brace
1 Bolt
• 1.5 Nm
2 Left Lock Carrier Brace
• Attached to the mounting bracket with the nut - 6 -.
3 Lock Carrier
4 Spring Nut
• Slide into the lower lock carrier.
5 Subframe
6 Nut
• 23 Nm