Ignition Coil: Service and Repair

Ignition Coils with Power Output Stages

Special tools, testers and auxiliary items required

• Ignition Coil Puller (T40039)

Removing






The following steps are only required for the ignition coils from cylinders 2 and 3.

- Remove the vacuum hose - 1 - from the air guide hose connection.

- Loosen the clamps - arrows - and remove the air guide pipe.

All

- Remove the left and right bolts - arrows - and disconnect the connectors from the ignition coils.






- Lay the electrical wiring harness down slightly.

• Ignore - 1 and 2 -.

- Remove the ignition coils using the (T40039).






Installing

• For the correct tightening specifications, refer to => [ Ignition Overview ] Service and Repair.

Install in reverse order, paying attention to the following:

• The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

• Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the Electronic Parts Catalog (ETKA).

• To mount the air guide hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.