ABS Indicator Does Not Come ON
ABS indicator does not come on1. Turn the ignition switch ON (II), and watch the ABS indicator. Does the ABS indicator come on?
YES - The system is OK at this time.
NO - Go to step 2.
2. Apply the parking brake.
Does the brake system indicator come on?
YES - Go to step 3.
NO - Repair open in the indicator power source circuit. If necessary, substitute a known-good gauge control module, and recheck.
3. Turn the ignition switch OFF.
4. Disconnect the ABS modulator-control unit 25P connector.
5. Turn the ignition switch ON (II).
Does ABS indicator come on?
YES - Check for loose terminals in the ABS modulator-control unit 25P connector. If necessary, substitute a known-good ABS modulator-control unit, and recheck.
NO - Go to step 6.
6. Turn the ignition switch OFF.
7. Remove the gauge control module.
8. Disconnect the gauge control module connector (30P) ('03-05 models), (36P) ('06-07 models).
9. Check for continuity between the gauge control module connector and body ground.
^ '03-05 models: Check between the gauge control module connector (30P) terminal No. 27 and body ground.
^ '06-07 models: Check between the gauge control module connector (36P) terminal No. 33 and body ground.
Is there continuity?
YES - Repair short to body ground in the wire between the gauge control module and the ABS modulator-control unit.
NO - Check for loose terminals in the gauge control module connector. If connector is OK, replace the gauge control module.