Side Air Bag Module

Side Air Bag Module

Removal

NOTE:
Removal steps in this procedure may contain installation details.
1 Make the air bag supplemental restraint system (SRS) safe. For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Disconnect the battery ground cable. For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect
3 Remove the front seat. For additional information, refer to Front Seat Removal and Replacement




4 Remove the front seat backrest lower rear cover.




5 Remove the front seat hinge cover.




6 Remove the front seat backrest cover upper trim panel.




7 Release the front seat backrest cover.




8
WARNING: The SRS electrical connectors are unique. DO NOT force, or attempt to connect electrical connectors to the wrong sockets.
Disconnect the side air bag module electrical connector.




9 Release the retaining strap.





10 TORQUE: 7 Nm





11 Release the locking tab.





12 Remove the side air bag module.

Installation
1 To install, reverse the removal procedure.
2 If a new component has been installed, configure using Jaguar approved diagnostic equipment.