Traction Off Indicator On With No DTC Set

Part 1 Of 2:

Part 2 Of 2:

CIRCUIT DESCRIPTION
For vehicles equipped with a U23 or a UH8 instrument cluster, the TRACTION OFF indicator is controlled by the EBCM/EBTCM via serial data UART.

For vehicles equipped with a UB3, a U2F, or a U50 instrument cluster, the TRACTION OFF indicator is controlled by the EBCM/EBTCM via the brake lamp driver module. The instrument cluster or remote indicator bank supplies voltage to the indicator. The brake lamp driver module acts as an inverter. When the EBCM/EBTCM supplies ground to the brake lamp driver module, the indicator remains OFF. When the EBCM/EBTCM removes ground from the brake lamp driver module, the brake lamp driver module supplies ground to the TRACTION OFF indicator.

DIAGNOSTIC AIDS
^ Buick uses the U23 and the UB3 instrument clusters.
^ Oldsmobile uses the UH8 instrument cluster.
^ Pontiac uses the UB3, the U2F, and the U50 instrument clusters.
^ It is very important that a thorough inspection of the wiring and connectors be performed. Failure to carefully and fully inspect wiring and connectors may result in misdiagnosis, causing part replacement with reappearance of the malfunction.
^ An intermittent malfunction can be caused by poor connections, broken insulation, or a wire that is broken inside the insulation.
^ If an intermittent malfunction exists, refer to Intermittents and Poor Connections Diagnosis.

TEST DESCRIPTION
The number below refer to the step number on the diagnostic table.
2. This step inspects to see if the cluster is hard wired, or controlled by serial data.