Steering Column Switch Base Carrier, Valeo

Steering Column Switch Base Carrier, Valeo

Special tools, testers and auxiliary items required

• Angled Hand Drill

• Torque Wrench (V.A.G 1410)


The removal and installation of individual steering column switch components must be done in a specified sequence. Refer to=> [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.

• The shear bolts - 1 - on the electronic steering column lock control module (J764) must be drilled out in order to remove the steering column switch base carrier - 2 -. New shear bolts will be needed for installation later.







• Before drilling out shear bolts, always make sure all components secured to steering column switch base carrier are removed beforehand.

• By drilling out, drill shavings can reach the neighboring components, which can lead to damage and malfunctions!

• When removing steering column switch components, observe specified sequence. Refer to=> [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.


When disconnecting and connecting the Battery, the procedure must be followed as described in the repair information. Refer to=> [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Removal

- Disconnect the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove all the components attached to the steering column switch base carrier in the sequence given. Refer to => [ Steering Column Switch Components, Removal and Installation Sequence ] Steering Column Switch Components, Removal and Installation Sequence.

The steering column switch base carrier can be removed one all the components attached to it are removed.

- Drill out the shear bolts - 1 - on the electronic steering column lock control module (J764) - 3 -.






• Bolts M8 - 1 -, core hole diameter 6.8 mm.

- Disconnect the connector on the back of the electronic steering column lock control module - 3 - and then remove the control module together with the steering column switch base carrier - 2 - from the steering column.

- Open the tabs - arrows - on the steering column switch base carrier and remove the steering column switch base carrier - 1 - from the electronic steering column lock control module - 2 -.






Installation

- Install the steering column switch base carrier - 1 - on the electronic steering column lock control module - 2 -.






- Slide the steering column combination switch (E595) onto the steering column switch base carrier until it latches.

- Slide the pre-assembled unit from the electronic steering column lock control module (J764) , the steering column switch base carrier and the steering column combination switch all the way onto the steering column and line them up with the threaded holes.

- Secure the electronic steering column lock control module - 1 - to the steering column with new shear bolts.






- Tighten the shear bolts - 1 - until the bolt heads shear off.

Further installation is in the reverse sequence to removal.

• Always code a new electronic steering column lock control module (J764) after installing it. Refer to => [ Electronic Steering Column Lock Control Module, with KESSY Coding ] Electronic Steering Column Lock Control Module (J764), with KESSY Coding