Rear Door Window

Rear Door Window

• Removing and installing is described only for the right rear door window. Removing and installing the left rear door window is similar

• When removing and installing door window, spreader pin and spreader plug are also accessible from outside when outer door plate has been removed.

Removing

- Remove rear door trim.

- Pry out cover caps - 5 -.





- Lower door window until spreader pin - 3 - and spreader plug - 4 - are accessible in window regulator cut-out.

• If this cannot be done because of a power window malfunction, remove the window regulator motor and then slide the window down.

- Screw in a 5 mm bolt (approx. 70 mm long) into spreader pin - 3 - and pull bolt out of spreader plug - 4 -.

- Screw a 8 mm bolt (approx. 80 mm long) into spreader plug - 4 -.

• When screwing the bolt into spreader plug, do not use excessive force on the plug otherwise it may fall inside into the door.

- Pull spreader plug - 4 - our of clamping bracket - 1 - and thereby out of door window.

- Pull window guide - 3 - out of mount.





- Remove bolts - 2 - and pull off panel - 1 - in direction of B-pillar - direction of arrow -.

- Pull door window upward - arrow - out of window shaft.





Installing

• Spreader plug and spreader pin must always be replaced when performing assembly work on door window.

• Before inserting spreader plug and spreader pin, check window for damage.

- With door window - 1 - removed, insert spreader plug - 3 - centered.





- Press spreader pin - 2 - flush into spreader plug - 3 -.

- Guide door window - 1 - into door and insert door window onto mount of window regulator guide - 4 -.

- Using a light pressure from above - arrow -, engage window - 1 - into window regulator guide - 4 -.

- Continue by performing the steps used in removal in reverse order.

• A function test must be performed before door trim is installed.