Relay Carrier on Vehicle Electrical System Control Module (J519)

Relay Carrier on Vehicle Electrical System Control Module (J519)

• The relay carrier is clipped to the vehicle electrical system control module and can be removed.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove the trim from the footwell on the driver side.

- Remove the left footwell lamp in the driver footwell. Refer to => [ Left Footwell Lamp (W9) ] Left Footwell Lamp (W9).

• The wiring for the left footwell lamp and the diagnostic socket can remain connected.

- Remove the footwell vent on the driver side.


• Risk of the airbag deploying!

• The airbag could deploy if the unit is mishandled.

• Follow all safety precautions when working with airbags.

- Remove the knee airbag in the driver footwell.

- Open both tabs - arrows - and pull the relay carrier - 2 - from the vehicle electrical system control module - 1 - opposite the drive direction.






- Swing the relay carrier downward and unclip the relay. Pay attention the wire still connected.

Installation

Install in reverse order.