Mirror Adjusting Unit

Mirror Adjusting Unit

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1783)

• The following describes removing and installing the right adjusting unit and motor. Removing and installing left adjusting unit and motor is identical.

Removing






- Remove the mirror glass. Refer to => [ Mirror Glass ] Mirror Glass.

- Remove the bolts - 2 - (quantity: 3) and remove the adjuster unit and motor - 1 - from the mirror base.

- Move the adjuster unit - 1 - to the side and disconnect the connector - 3 -.

Installation






- Connect the connector - 3 - to the adjuster unit - 1 -.

- Mount the adjuster unit - 1 - on the mirror base and tighten the screws - 2 - (quantity: 3).

Tightening specification - 2 -: 2 Nm

- Install the mirror glass. Refer to => [ Mirror Glass ] Mirror Glass.

• Perform function test.