Knock Sensor: Service and Repair

Knock Sensors

CAUTION!
• Fuel system is under high pressure! Before opening high pressure components of the fuel injection system, pressure must be relieved to residual pressure. Refer to => [ Before Opening High Pressure Fuel Injection System ] Service and Repair.

• Then wrap a clean rag around the connection and relieve residual pressure by carefully loosening the connection.

Installation location, connectors on the front of the engine





7 Knock sensor 4 (G199) (blue connector)
8 Knock Sensor 3 (G198) (white connector)
9 Knock Sensor (KS) 1 (G61) (orange connector)
10 Knock Sensor (KS) 2 (G66) (gray connector)

Installation location, knock sensors on the inside of the cylinder head





1 Engine Coolant Temperature (ECT) Sensor (G62)
2 Knock Sensor (KS) 4 (G199)
3 Knock Sensor (KS) 3 (G198)
4 Fuel Pressure Sensor (G247)
5 Knock Sensor (KS) 1 (G61)
6 Knock Sensor (KS) 2 (G66)
7 Camshaft Adjustment Valve 1 (N205)
8 Low Fuel Pressure Sensor (G410)

- Remove intake manifold. Refer to => [ Intake Manifold ] Intake Manifold.

• Seal intake channels in cylinder heads with a clean cloth.

- Remove each knock sensor.

Installing

- Attach respective removed knock sensor in its installation location.

• Tightening Specifications Ignition. Refer to => [ Ignition Assembly Overview ] Ignition Assembly Overview

• Tightening specifications affects function of Knock Sensor (KS).

- Install intake manifold. Refer to => [ Intake Manifold ] Intake Manifold.