A/C Compressor Belt Pulley, Denso Version 2 Overview

A/C Compressor Belt Pulley, Denso Version 2 Overview

• This type of belt pulley is installed on a 7 SEU 17 A/C compressor.

• Different versions of the pulley may be installed, depending on A/C compressor construction type and engine version. Refer to Electronic Parts Catalog (ETKA).

• Belt Pulley, removing and installing, refer to => [ Belt Pulley, Denso Version 2 ] Belt Pulley, Denso Version 2.






1 - Circlip

• Remove carefully using a small screwdriver or needle-nose pliers (especially note belt pulley when doing this).

• As of model year 2006, circlips with a rubber disc vulcanized on to them are installed as a running change, this rubber disc replaces the plastic disc which could be glued on up to then (not present on all compressors). Refer to=> [ Belt Pulley, Denso Version 2 ] Belt Pulley, Denso Version 2.

• Removing and installing, refer to => [ Belt Pulley, Denso Version 2 ] Belt Pulley, Denso Version 2.

2 - Drive Plate

• Tightening specification 35 Nm.

• Attached to the A/C compressor input shaft.

• Different versions. Refer to Electronic Parts Catalog (ETKA).

• The overload protection takes over when the torque is excessive (for example, if the A/C compressor runs with resistance) and the belt pulley runs freely without driving the A/C compressor.

• Removing and installing, refer to => [ Belt Pulley, Denso Version 2 ] Belt Pulley, Denso Version 2.

• A plastic washer may be glued on, depending on time period of production. Refer to=> [ Belt Pulley, Denso Version 2 ] Belt Pulley, Denso Version 2.

3 - Circlip

• Replace

• Install on correct side (flat side toward A/C compressor).

• Removing and installing, refer to => [ Belt Pulley, Denso Version 2 ] Belt Pulley, Denso Version 2.

4 - Spacer

• Dimension: 17.5 x 10 x 3 mm

5 - Rubber Elements

• 6x, Install on proper side. Refer to=> [ Belt Pulley, Denso Version 2 ] Belt Pulley, Denso Version 2.

• Decouples belt pulley from A/C compressor input shaft, damps vibrations and noise.

• For installation, lightly coat rubber elements, for example, with tire mounting paste or a soap solution (as a lubricant).

6 - Belt Pulley

• Belt pulley is made of plastic and is sensitive to impact, therefore handle it with especial care.

• Different versions. Refer to Electronic Parts Catalog (ETKA).

• Removing and installing, refer to => [ Belt Pulley, Denso Version 2 ] Belt Pulley, Denso Version 2.

7 - A/C Compressor

• Different versions may be installed, depending on engine version and country version of vehicle. Refer to Electronic Parts Catalog (ETKA).

• Clean A/C compressor flange before sliding on pulley.