Engine Control Module: Testing and Inspection

Engine Control Module Voltage Supply, Checking

Special tools, testers and auxiliary items required

• multimeter.

• Wiring Diagram.

Test requirements

• Fuse (SA2) OK.

• Fuse (SB5) OK.

• Fuse (SB6) OK.

• The Ground (GND) connections at the engine and transmission OK.

• The battery voltage at least 12.5 V.

• The generator OK.

Test procedure

- Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] Preliminary Check.

Start diagnosis

If the manufacturers test box is being used, perform the following step.

- Install the test box.

If the manufacturers test box is not being used, perform the following step.

- Remove the Engine Control Module (J623). Refer to the appropriate service manual.

Checking voltage supply

- Using a multimeter, check the following wiring connection for voltage.

- Turn the key on






Specified value: 12.5 V

If the specified value was not obtained:

- Check the Engine Control Module (J623) electrical harness connector T94 terminal 19 to the Battery (A) positive terminal for an open circuit or short to Ground (GND).

- Check the electrical harness connectors for damage, corrosion, loose or broken terminals.

- If necessary, repair the wiring connection.

If no malfunctions are found in the wiring:

- Using a multimeter, check the following wiring connections for voltage.






Specified value: 12.5 V

- Switch the ignition off.

If the specified value was not obtained:

- Check the Engine Control Module (J623) electrical harness connector T94 terminal 3, 5, 6 to the Engine Component Power Supply Relay (J757) socket 4 for an open circuit or short to Ground (GND).

- Check the electrical harness connectors for damage, corrosion, loose or broken terminals.

- If necessary, repair the wiring connection.

If no malfunctions are found in the wiring:

Checking Ground (GND)

- Using a multimeter, check the following wiring connections for resistance.






Specified value: 1.5 ohms.

If any of the specified values are not obtained:

- Check the electrical harness connector for damage, corrosion, loose or broken terminals.

- If necessary, repair the wiring connection.

If no malfunctions are found in the wiring and the voltage supply was OK:

- Perform a road test to verify any electrical repairs.

If the fault does not return:

Generate readiness code. Refer to => [ Readiness Code ] Readiness Code.

If the fault does return and no malfunction is detected in the wiring and the voltage supply was OK:

- Replace the Engine Control Module (ECM) (J623). Refer to the appropriate service manual.

- Assembly is performed in the reverse of the removal.

Final procedures

After repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] Scan Tool Testing and Procedures.

2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] Scan Tool Testing and Procedures.

3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] Readiness Code.