Electronic Steering Column Lock Control Module (J764)

Electronic Steering Column Lock Control Module (J764)

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)

Removing

Note the following before removing the steering column:

Create a sketch showing the:

• Routing of the electrical wiring harnesses.

• Securing the electrical wiring harnesses.

• Cable tie locations.

This especially applies to the wiring harness to the electronic steering column lock control module (J764).

Note the following before installing the steering column:

• Route the electrical wiring harnesses exactly the way they were before removal.

• Secure the electrical wiring harnesses exactly the way they were before removal.

• Install all the cable ties that were loosened or cut in the same locations when installing the steering column.

• Make sure the wiring harness to the electronic steering column lock control module is not pinched and does not come into contact with sharp edges when adjusting the steering column.

- Remove the steering column. Refer to => [ Steering Column ] Steering Column.

- Remove the bolt - 1 - and the electronic steering column lock control module - 2 -.






• After removing the control module, make sure no dirt or foreign objects enter the steering column.

Installing

Install in reverse order of removal. Note the following:

Tightening specification, refer to => [ Steering Column Overview ] Steering Column Overview.

• If only the electronic steering column lock control module was replaced, used the previously used control module bolt.

• If the steering column was replaced, then remove the protective cover and use the bolts in the new steering column for the electronic steering column lock control module.

- Insert the electronic steering column lock control module with the tab - arrow A - into the groove - arrow B - in the steering column and then push on the electronic steering column lock control module by hand.






- Once the electronic steering column lock control module - 2 - touches the entire surface of the steering column, install the bolt - 1 - and tighten it.






- Install the steering column. Refer to => [ Steering Column ] Steering Column.

- Perform the following work using the vehicle diagnostic tester in "Guided Functions" if the electronic steering column lock control module was replaced.

- If the steering angle sensor (G85) indicator lamp in the instrument cluster comes on, correct the fault and, if necessary, perform a basic setting on the dynamic steering. Refer to => [ Dynamic Steering Basic Setting ] Dynamic Steering Basic Setting.