Distance Regulation Control Module Clip

Distance Regulation Control Module Clip

If the stud bolt is being removed, then the clip - item 2 - => [ (Item 2) Stud ] Distance Regulation Control Module (J428) and Distance Regulation Control Module 2 (J850) Overview must always be replaced - item 3 - => [ (Item 3) Clip ] Distance Regulation Control Module (J428) and Distance Regulation Control Module 2 (J850) Overview.

The clip will get damaged when it is being removed.

• The distance regulation control module (J428) and distance regulation control module 2 (J850) are removed and the nuts are removed from the stud bolts.

- Remove the stud bolt - 1 - with a suitable tool - 2 -.






- Place a screwdriver between the hook and the housing.






- Using the screwdriver, bend the hook to the center point until it audibly breaks off.

• Repeat this until all the hooks are broken.

- To prevent the broken hooks from getting caught on the housing, remove them using needle nose pliers.

- Remove the clip with needle nose pliers as illustrated.

- Insert the new clip into the hole for the housing from the left side and push it in by hand until it audibly engages.






• Make sure the tabs are lined up correctly.

- Mount the stud bolt making sure is it parallel to the hole.

- The stud bolt can be tighten once it is correctly aligned.

- Install the stud bolt until the dimension - a - is reached.






Dimension - a - = 43.3 mm (1.7 in.)

- Repeat this on the other clips.

- Install the ACC sensor into the bracket and adjust it. Refer to => [ Adaptive Cruise Control Sensor, Adjusting ] Service and Repair.