Engine Speed Sensor: Service and Repair

Engine Speed (RPM) Sensor (G28)

Removing






- On a vehicle with air suspension, activate vehicle lift mode.

- Remove the noise insulation - 1 - and - 2 -..

Risk of distorting airbag spiral spring.

• Separate universal joint from steering gear only when front wheels are in the straight ahead position.

• Secure steering wheel with adhesive tape to prevent position of steering wheel and steering gear from changing.

- Remove the 2 bolts and then remove the steering gear heat shield - A -.






- Remove the universal joint bolt - B -.

- Remove universal joint from steering gear.

- Remove the bolts - 2 - to be able to lower the rear subframe.






The subframe could cause an accident if it is not secured.

• Do not loosen the subframe bolts - 1, 3 and 4 -.

- Disconnect the connector - 3 -.






- Remove the cover - 2 -.

- Remove the bolt - 1 - and remove the RPM sensor.

Installing

Install in reverse order of removal.

• Tightening specification, refer to => [ Ignition Overview ] Service and Repair.

- Install subframe.

- Install universal joint on steering gear.

- Install the noise insulation.

- On a vehicle with air suspension, deactivate vehicle lift mode.