Garage Door Opener Transmitter: Service and Repair

Garage Door Opener Replacement

Removal Procedure




1. Remove the overhead console.
2. Remove the two garage door opener (GDO) fasteners (3).
3. Disconnect the electrical connector (4).
4. Remove the GDO (5).

Installation Procedure




1. Connect the garage door opener (GDO) electrical connector (4).
2. Place the GDO (5) into the overhead console. Ensure the GDO buttons are placed correctly in their designated openings.

Notice: Refer to Fastener Notice.

3. Install the fasteners (3).

Tighten the fasteners (3) to 2 N.m (18 lb in).

4. Install the overhead console.
5. Program the GDO. Refer to Control Module References for programming and setup information.