Rear Knuckle Alignment Link: Service and Repair

Adjustment Link Replacement

Tools Required

J 24319-B Steering Linkage Puller

Removal Procedure




1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the nut from the adjustment link.




3. Use the J 24319-B to separate the adjustment link from the control arm.
4. Remove the exhaust.
5. Remove the rear suspension support.




6. Remove the cam lock nut and the bolt.
7. Remove the adjustment link from the support assembly.

Installation Procedure




1. Install the adjustment link to the support assembly.

Notice: Refer to Fastener Notice.

2. Install the cam lock nut, washer and bolt.

Tighten the cam lock nut to 91 N.m (67 lb ft).




3. Install the adjustment link to the control arm.
4. Install the adjustment link nut.

Tighten the nut to 30 N.m (22 lb ft) then tighten an additional 180 degrees.

5. Install the rear suspension support.
6. Install the exhaust.
7. Lower the vehicle.
8. Check the rear toe adjustment.