Intake Resonance Switchover Solenoid Replacement

INTAKE RESONANCE SWITCHOVER SOLENOID REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the following from the intake resonance switchover solenoid:
- The electrical connector

IMPORTANT: Observe the proper positions of the vacuum hoses.

- The vacuum hoses
2. Remove the intake resonance switchover solenoid screws.
3. Remove the intake resonance switchover solenoid from the intake air resonator.

INSTALLATION PROCEDURE




1. Position the intake resonance switchover solenoid to the intake air resonator.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the intake resonance switchover solenoid screws.

Tighten
Tighten the intake resonance switchover solenoid screws to 3 N.m (27 lb in).

3. Connect the following to the intake resonance switchover solenoid:
- The electrical connector

IMPORTANT: Properly position the vacuum hoses as previously noted during removal.

- The vacuum hoses