Operation CHARM: Car repair manuals for everyone.

A/T - Firm 1-2 and 3-2 Flare Shifts

Number: 83-T-66

Section: VIIc

Date: July, 1983
Subject: FIRM 1-2 AND 3-2 FLARE SHIFTS ON THM 125C
TO: ALL CHEVROLET DEALERS


1983 THM 125C CA, CB and CF model transmissions may experience a firm 1-2 shift or 3-2 shift flare at times.

To correct these shift conditions, a new control valve assembly went into production in early November, 1982. This new control valve assembly will soften the 1-2 shift feel and eliminate the 3-2 shift flare.

When servicing any CA, CB or CF model THM 125C transmission, for these shift conditions, built prior to transmission serial numbers, CA-1360, CB-28411 and CF-2968, a service package has been made available. Refer to the following service procedure:

CONTROL VALVE ASSEMBLY:




SERVICE PROCEDURE

1. Remove the control valve assembly from the transmission.

2. Remove the retaining pin from the 1-2 accumulator bore in the control valve assembly (see illustration).

NOTICE: Note the location of the hole in the 1-2 accumulator bushing that the retaining pin locates thru.

3. Remove the 1-2 accumulator plug, valve, bushing and spring and replace the valve, spring and bushing with parts contained in service package #8643998. (1-2 accumulator spring will be orange in color and will be the smallest spring in diameter, of the two springs contained in the package.)

4. Install the retaining pin into the bore thru the top hole in the bushing. The pin must be flush or below the bottom face of the valve control assembly.

5. Remove the spring retaining sleeve from the 3-2 control valve bore in the valve body (see illustration below).

6. Replace the 3-2 control valve spring with the spring contained in the service package. (The 3-2 control valve spring will be yellow in color and larger in diameter than the 1-2 accumulator spring.)

7. Replace the spring retaining sleeve into the valve body. The retaining sleeve must be flush or below the bottom face of the control valve assembly.

8. Install the control valve assembly onto the transmission following procedures outlined in the service manual.