Valve Body Cover Replacement

REMOVAL PROCEDURE





1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove the transmission bracket.
3. Remove the control valve body cover bolts.





4. Remove the control valve body cover.
5. Remove the valve body cover gasket.





6. Determine if the washer is inverted on the bolts.

IMPORTANT: Use Sealant compound GM P/N 12345282, or equivalent in order to reduce the potential for oil leaks on bolts.

INSTALLATION PROCEDURE





1. Install the valve body cover gasket.
2. Install the control valve body cover.





3. Install the control valve body cover bolts.
^ Tighten the bolts to 24 Nm (18 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

4. Install the transmission mount bracket.
5. Connect the negative battery cable.