Finding A Station

AM-FM: Press this button to switch between AM, FM1 and FM2. The display shows your selection.

TUNE: Press this knob lightly so it extends. Turn it to choose radio stations. Push the knob back into its stored position when you're not using it.

SEEK: Press the right or left arrow to go to the next higher or lower station and stay there. The sound will mute while seeking.

SCAN: Press one of the "SEEK" arrows for 2 seconds, and "SCAN" will appear on the display. Use "SCAN" to listen to stations for a few seconds. The radio will go to a station, stop for a few seconds, then go on to the next station. Press "SEEK" again to stop scanning. The sound will mute while scanning.

PUSHBUTTONS: The six numbered pushbuttons let you return to the owner's favorite stations. You can set up to 18 stations (six AM, six FM1 and six FM2).
Just:
1. Press "AM-FM" to select the band.
2. Tune in the desired station.
3. Press "AUTO TONE" to select the equalization that best suits the type of station selected.
4. Press and hold one of the six numbered buttons. The sound will mute. When it returns, release the button. Whenever you press that numbered button, the station you set will return and the "AUTO TONE" equalization that you selected will also be automatically selected for that pushbutton.
5. Repeat the steps for each pushbutton.

P.SCAN: Press this button to listen to each of the favorite stations stored on the pushbuttons for a few seconds. The radio will "SCAN" through each of the stations stored on the pushbuttons, except those stations with weak reception. The "AUTO TONE" setting stored for that pushbutton will be automatically chosen. Press "P.SCAN" or one of the pushbuttons again to stop scanning. "P.SCAN" will be displayed whenever the tuner is in the "P.SCAN"" mode. The channel number (P1 -P6) will appear momentarily just before the frequency is displayed.