Lift Off Panel Weatherstrip Retainer Replacement

Lift Off Panel Weatherstrip Retainer Replacement

Removal Procedure




1. Remove the roof panel.




2. Remove the side weatherstrip.
3. Mark the location of the retainer.
4. Remove the screws attaching the retainer.
5. Remove the retainer by gently pulling the retainer loose from the roof panel.
6. Clean the retainer and the roof panel contact surfaces to remove any old foam sealing tape.

Installation Procedure

Important: A minimum of 2 mm (0.08 in) of foam sealing tape must extend beyond the edge of the retainer to prevent water leaks.




1. Apply foam sealing tape to a reusable retainer.
2. Apply a bead of sealer across the front of the window blow out clip above the screw hole as shown in the illustration.
3. Install the clip to the retainer aligning the clip to the front hole in the retainer.




4. Apply a bead of sealer across the full length of the back of the retainer outside the screw holes as shown in the illustration.
5. Position the retainer to the marks made before removal.

Notice: Refer to Fastener Notice in Service Precautions.

6. Install the forward screw aligning the retainer fore and aft.

Important: Stripped, broken, or improperly seated screws must be replaced or repaired to prevent water leaks.

7. Install the remaining screws.

Tighten the side weatherstrip retainer screws to 3.4 N.m (30 lb in).




8. Apply a bead of sealer to the ends of the retainer and install the side weatherstrip. Refer to Lift Off Panel Weatherstrip Replacement.
9. Install the roof panel.