Assembly Procedure

Assembly Procedure





1. Install the flow control spring (2) to the housing (1).
2. Install the control valve assembly (3) to the housing (1).
3. Lubricate the O-ring seal (4) with power steering fluid.
4. Install the new O-ring seal (4) onto the O-ring union fitting (5).
5. Install the O-ring union fitting (5) into the pump housing (1).
- Tighten the union fitting (5) to 75.0 Nm (55 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.