Wheel Speed Sensor Replacement (Rear)

Removal Procedure

Important: The rear wheel speed sensors and rings are integral with the hub and bearing assemblies.

If a speed sensor or a ring needs replacement, you must replace the entire hub and bearing assembly.





1. Raise and support the vehicle on a suitable hoist. Refer to Vehicle Lifting.
2. Remove the rear tire and wheel assembly.
3. Remove the rear wheel speed sensor electrical connector (1). Located next to rear strut (2).





4. Remove the hub and bearing assembly (1). Refer to Wheel Bearing/Hub Replacement - Rear.

Installation Procedure





1. Install the hub and bearing assembly (1) to the vehicle. Refer to Wheel Bearing/Hub Replacement - Rear.





2. Install the rear wheel speed sensor electrical connector (1).
3. Install the wheel and tire assembly.
4. Lower the vehicle.
5. Turn the ignition switch to the ON position with the engine off.
6. Perform the Diagnostic System Check. Refer to A Diagnostic System Check - ABS.