Transmission Mount Replacement - Left

Transmission Mount Replacement - Left

Removal Procedure
1. Remove the washer solvent container.





2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Remove the left front wheel and tire assemblies.
4. Remove the left front fender liners.

Important: In order to avoid oil pan damage and possible engine failure, insert a block of wood that spans the width of the oil pan bottom between the oil pan and the jack support.

5. Position these items in order to support the transaxle:
^ A block of wood
^ A jack stand





6. Remove the transaxle mount through-bolt.





7. Remove the transaxle to engine block bolts.
8. Remove the front transaxle mount.

Installation Procedure





1. Install the front transaxle mount.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the front transaxle mount bolts.
^ Tighten the bolts to 75 Nm (60 ft. lbs.).
3. Install the front transaxle mount through-bolt.
^ Tighten the bolt to 60 Nm (44 ft. lbs.).
4. Install the left front fender liner.
5. Install the left front tire and the wheel assembly.
6. Remove the jack stand.
7. Lower the vehicle.
8. Install the washer solvent container.