Transmission Fluid Cooler Pipe Seal Replacement

Transmission Fluid Cooler Pipe Seal Replacement

Special Tools

* DT-45201 - Cooler Line Seal Remover

* DT-47770 - Seal Installer

For equivalent regional tools, refer to Special Tools Tools and Equipment.

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the front compartment air deflector.

3. Remove the Left Catalytic converter. Refer to Catalytic Converter Replacement - Left Side (V8) Catalytic Converter Replacement - Left Side (V8)Catalytic Converter Replacement - Left Side (LFX) .

4. Remove the differential line cooler retainers and the right side cooler line retainers from the oil pan.




5. Remove the transmission fluid cooler pipe bolt (2) from the transmission.

6. Remove the transmission fluid cooler pipes from the transmission.




7. Using DT-45201 - remover, remove the transmission fluid cooler pipe seals from the transmission.

Installation Procedure




1. Using DT-47770 - installer, install the transmission fluid cooler pipe seals (1) in the transmission.




2. Install transmission fluid cooler pipes (1) the to the transmission.

Caution: Refer to Fastener Caution Fastener Caution.

3. Install the transmission fluid cooler pipe bolt (2) to the transmission and tighten to 22 Nm (16 lb ft).

4. Install the differential line cooler retainers and the right side cooler line retainers to the oil pan.

5. Install the Left Catalytic converter. Refer to Catalytic Converter Replacement - Left Side (V8) Catalytic Converter Replacement - Left Side (V8)Catalytic Converter Replacement - Left Side (LFX) .

6. Install the front compartment air deflector.

7. Lower the vehicle.

8. Check the transmission fluid level.