Power Mirror Motor: Service and Repair

Power Mirror Actuator Replacement

'06-07 models

NOTE: Do not cut the wire harness excluding Power Mirror Actuator replacement operation.

1. Remove the power mirror.
2. Disconnect the 13P connector.
3. Carefully remove the mirror holder from the mirror housing. Gently pull it out by hand.




4. Remove the cover (A), then remove the screw from the bracket (B).
5. Record the terminal locations and wire colors.
6. Cut the wire harness with the wire cutter.




7. Remove the three screws, and separate the mirror housing (A) from the bracket (B).




8. Remove the three screws and separate the mirror holder housing (A) from the mirror housing (B).




9. Remove the screw and separate the actuator (A) from the housing (B).
10. Disconnect the 2P connector (C) from the side turn signal light (D).




11. Route the wire harness (A) of the new actuator (B) through the hole in the bracket (C).
12. Install the new actuator in the reverse order of removal.




13. Insert the terminals into the connector in the original arrangement as shown.

NOTE: All connector views are from wire side of female terminals

14. Reassemble in the reverse order of disassembly. Be careful not to break in the mirror holder when reinstalling it to the actuator.
15. Reinstall the mirror assembly to the door.
16. Operate the power mirror to ensure smooth operation.
17. Operate the side turn signal light ensure operation.