Fluid Line/Hose: Service and Repair

ATF Cooler Hose Replacement

1. Slide the ATF cooler hoses (A) on the ATF filter (B) until they touch the filter housing, and secure the hoses with the clips (C) at 6-8 mm (0.24-0.31 in.) (D) from the filter housing.





2. Slide the ATF cooler hoses (E) over the ATF cooler line (F) until the hose ends contact the bulge (G), and secure the hoses with the clips (H) at 6-8 mm (0.24-0.31 in.) (I) from the hose end.
3. Slide the ATF cooler hoses (J) over the ATF lines (K) until the hose ends contact the bulge (L), and secure the hoses with the clips (M) at 6-8 mm (0.24-0.31 in.) (N) from the hose end.
4. Install the hose (O) on the clamp (P) at the mark (Q).