Fuel Injection Pump Belt

Fuel Injection Pump Belt

Removal
1. Disconnect the battery ground cable.
2. Remove the secondary bulkhead center panel.
3. Remove the fuel injection pump belt cover.





4. Remove and discard the fuel injection pump belt tensioner.





5. Note the direction of rotation of the fuel injection pump belt.





6. Remove and discard the fuel injection pump belt.





Installation

1. NOTE: The fuel injection pump rotates in an anti-clockwise direction when viewed from the rear of the engine.

Note the direction of rotation of the new fuel injection pump belt.





2. CAUTION: Do not install the fuel injection pump belt to the pulleys with the fuel injection pump belt tensioner installed. Failure to follow this instruction may result in damage to the fuel injection pump drive belt.

NOTE: Make sure the fuel injection pump belt is correctly seated on to the fuel injection pump drive pulleys.

Install a new fuel injection pump belt.





3. CAUTION: Make sure the fuel injection pump belt tensioner is correctly located in to the fuel injection pump cover back plate. Failure to follow this instruction may result in damage to the components.

Install the fuel injection pump belt tensioner.

^ Locate the tang on the new fuel injection pump belt tensioner in to the fuel injection pump cover back plate.





4. NOTE: Do not remove the fuel injection pump belt tensioner locking pin before installing the tensioner.

Install the fuel injection pump belt tensioner retaining bolt.

^ Tighten to 25 Nm.





5. Remove and discard the fuel injection pump belt tensioner locking pin.





6. Install the fuel injection pump belt cover.





7. Install the secondary bulkhead center panel.
8. Connect the battery ground cable.