Part 2

Engine

64 Disconnect the knock sensor electrical connectors.





65
NOTE:
Left-hand shown, right-hand similar.
Remove the ignition coil cover.

Vehicles without supercharger





66 Remove the engine cover retaining bracket.





67 Remove the engine cover retaining bracket.

All vehicles





68
NOTE:
Right-hand shown, left-hand similar.
Detach the engine wiring harness.





69
NOTE:
Right-hand shown, left-hand similar.
Disconnect the fuel injector electrical connectors.





70 Disconnect the ignition on-plug coil electrical connectors.





71 Detach the engine wiring harness.





72 Detach the engine wiring harness.





73 Disconnect the camshaft position sensor electrical connector.





74 Detach the engine wiring harness.
Detach the ground cable.
Disconnect the variable valve timing (VVT) solenoid electrical connector.
1) Detach the engine wiring harness.

Vehicles with supercharger





75 Detach the engine wiring harness.
- Remove the retaining bolt.





76 Detach the engine wiring harness.

Vehicles without supercharger





77 Disconnect the positive crankcase ventilation pipe.





78 Disconnect the fuel pressure regulator electrical connector.





79 Disconnect the exhaust gas recirculation valve electrical connector.





80 Disconnect the exhaust gas recirculation valve coolant hose.

All vehicles





81 Detach the engine wiring harness.





82 Disconnect the fuel injector electrical connectors.





83 Detach the engine wiring harness.





84 Disconnect the ignition on-plug coil electrical connectors.





85 Disconnect the fuel temperature sensor electrical connector.





86 Disconnect the camshaft position sensor electrical connector.





87 Detach the engine wiring harness

Vehicles without supercharger





88 Detach the engine wiring harness.





89 Remove the intake manifold.

Vehicles with supercharger





90 Remove the lower intake manifold.

All vehicles





91
NOTE:
Place a suitable container underneath the filter to prevent oil spillage.
Remove the oil filter element.

Vehicles without supercharger





92 Remove the oil cooler.
- Remove and discard the O-ring seal.

All vehicles





93 Disconnect the oil pressure switch and oil temperature sensor electrical connectors.





94 Remove the oil filter housing.
- Remove and discard the O-ring seal.





95 Detach the right-hand oxygen sensor.





96 Detach the engine wiring harness retaining clips.

97 Remove the engine wiring harness





98 Remove the noise and vibration insulating pad.





99 Remove the intake manifold heater coolant hose.
1) Remove the knock sensors.
2) Remove the intake manifold heater coolant hose.





100 Remove the engine block insulation grommet.





101 Remove the water pump pulley.
- Using the special tool, retain the water pump pulley.





102 Remove the water pump.
- Remove and discard the gasket.
- Remove and discard the O-ring seal.

Vehicles without supercharger





103 Remove the thermostat housing.
- Remove and discard the O-ring seals.