Camshaft Position (CMP) Sensor RH

Camshaft Position (CMP) Sensor RH

Removal
1 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications [1][2]Battery
2 Remove the engine cover. For additional information, refer to Engine Cover Service and Repair




3 Disconnect the CMP sensor electrical connector.
- Slide the red connector latch to one side.




4 Release the CMP sensor electrical connector.




5 Remove the CMP sensor.
- Remove the Torx bolt.
- Remove and discard the O-ring seal.

Installation
1 Install the CMP sensor.
- Clean the components.
- Install a new O-ring seal.
- Tighten the Torx bolt to 7 Nm (5 lb.ft).
- Connect and secure the electrical connector.
2 Install the engine cover. For additional information, refer to Engine Cover Service and Repair
3 Connect the battery ground cable and install the cover. For additional information, refer to Specifications [1][2]Battery