Rear Door Child Safety Lock - Stiff Operation
Bulletin No.: 009/96Issued: 03/12/96
Revised:
Category
S
Applicable Model/s
1995 Protege
Subject
STIFF OPERATION OF THE REAR DOOR CHILD SAFETY LOCK
APPLICABLE MODELS/VINS
All 1995 Protege vehicles with a VIN of JM1BA****S0122206 and lower.
DESCRIPTION
The rear door child safety lock operation may be stiff. This may be caused by a bend in the locking mechanism set plate. To prevent this concern, the set plate configuration has changed to increase rigidity.
If a customer complains of any of the following, refer to the repair procedures in this bulletin.
^ Stiff operation when engaging the child safety lock.
^ The door can not be opened (from the inside) even with the child safety lock disengaged.
NOTE:
It is not necessary to replace the locking mechanism to correct this concern. Service Personnel should insure customers are familiar with the child lock functions.
REPAIR PROCEDURES
1. Confirm the complaint.
2. Remove the door trim.
3. Confirm that the door lock and door handle linkage are properly attached.
^ If properly attached, proceed to step 4.
^ If not attached properly or the linkage is bent, attach or straighten and check for proper operation.
4. Disconnect the linkage from the door handle and remove the door lock assembly.
5. Check the position of the set plate.
^ If the set plate is bent, proceed to step 6.
^ If the set plate is not bent, inspect the lock mechanism for other problems.
6. Remove the outer plastic cover from the lock mechanism.
7. Remove the child safety lock mechanism. Refer to Fig. 1.
8. Straighten the set plate. Refer to Fig. 2.
9. Assemble the child safety lock mechanism.
10. Install outer plastic cover.
11. Install lock assembly.
12. Attach the linkage to handle.
13. Confirm proper operation.
^ If the locking mechanism operates smoothly, install door trim.
^ If the lock is stiff or does not operate as designed, replace the lock assembly with a new part.
WARRANTY INFORMATION
(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term Information.)
Warranty Type: A
Symptom Code: 41
Damage Code: 9B
Part Number Main Cause: see table below
Quantity: 0
Operation Number: S1108XRX
Labor Hours: 0.5 Hrs.
Part Number Main Cause:
Part Number Description Feature
BC1D 72 310 Door Lock (R) Without Power Lock
BC1E 72 310 Door Lock (R) With Power Lock
BC1D 73 310 Door Lock (L) Without Power Lock
BC1E 73 310 Door Lock (L) With Power Lock