Rear

DISC PAD THICKNESS INSPECTION





1. Jack up the rear of the vehicle and support it on safety stands.
2. Remove the wheel and tires.
3. Look through the caliper inspection hole and inspect the remaining thickness of the pads.

THICKNESS 1.0 mm (0.04 inch)

4. Replace the pads as a set: right and left wheels, if either is less than the minimum thickness.

DISC PLATE THICKNESS INSPECTION
1. Measure the thickness of the disc plate.

CAUTION
^ When it is necessary to machine the disc plate, and the disc plate is removed from the vehicle then machined, excessive runout may result. Machine the disc plate which is installed on the vehicle.

Minimum 8 {0.31 inch}
Minimum thickness after machining by using a brake lathe on-vehicle 8.8 mm {0.35 inch}

2. If the thickness is not within the specifications, replace the disc plate.

DISC PLATE RUNOUT INSPECTION
1. Verify that there is no looseness in wheel bearing.
2. Measure the runout at the outer edge of the contact surface of the disc pad.

Runout: 0.05 mm (0.002 inch) maximum.





3. If the runout is not within the specification, repair or replace the disc plate.