Control Arm Bushing: Service and Repair
REMOVAL PROCEDURE^ Tools Required:
- J 34866 Control Arm Bushing Service Set
1. Remove the control arm from the vehicle. Refer to LOWER CONTROL ARM REPLACEMENT.
2. Use J 34865 and a press (1) to remove the rear bushing (2) from the control arm.
3. Remove the front control arm bracket nut and washers.
4. Remove the bracket (10) from the control arm (6).
5. Use a knife to cut the flange off of the front bushing.
6. Use J 34865 and a press to remove the front bushing (2) from the control arm (3).
INSTALLATION PROCEDURE
^ Tools Required:
- J 34865 Control Arm Bushing Service Set
1. Apply soap and water on the circumference of each bushing (2) in order to make the installation easier.
Important: Center the bushing (2) in the control arm (3).
2. Use J 34865 and a press (1) to install the front bushing (2) to the control arm (3).
3. Use J 34865 and a press to install the rear bushing (1) into the control arm (2).
4. Position the rear bushing (1) correctly.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.
5. Use the washers and the nut to install the front control arm bracket (10) to the control arm (6).
Tighten
Tighten the front control arm bracket nut to 125 Nm (92 ft. lbs.).
6. Install the control arm (6) to the vehicle. Refer to LOWER CONTROL ARM REPLACEMENT.