Band Apply Servo: Service and Repair

REMOVAL PROCEDURE

^ Tools Required
- J 35534 Piston Cover Depressor





1. Raise and suitably support the vehicle.
2. Remove 3 transaxle fluid pan bolts (1).





3. Install J 35534. Tighten the adjustment bolt on the J 35534 until you can remove the snap ring from the servo cover (1).





4. Remove the servo cover snap ring (11).
5. Remove the J 35534 after slowly loosening adjustment bolt.
6. Remove the following components:
^ The servo cover (10)
^ The servo piston (7)
^ The springs (4,5)
^ The piston rod (1)
7. Inspect the intermediate servo assembly.

INSTALLATION PROCEDURE

^ Tools Required
- J 35534 Piston Cover Depressor
- J 36850 Transjel Transmission Assembly Lubricant

NOTICE: After making sure all parts are clean, liberally apply J 36850 to all servo parts prior to assembly. This serves to prelubricate seals and to ensure ease of assembly.





1. Install the following components:
^ The piston rod (1)
^ The springs (4,5)
^ The piston (7)
^ The piston cover





2. Install J 35534 and tighten the adjustment bolt in order to install the snap ring on the servo cover (1).
3. Install the servo cover snap ring.
4. Remove the J 35534.





5. Install three transaxle fluid pan bolts (1) .
^ Tighten the fluid pan bolts to 6 Nm (53 inch lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

6. Lower the vehicle.
7. Refill the transaxle, as necessary.