Wiring Harness: Service and Repair

Wiring Harness Replacement

Removal Procedure

^ Tools Required
- J 41101 Transaxle Connector Remover

1. Remove the transmission side cover.
2. Remove the control valve body.





3. Push the J 41101 onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector's retaining tabs.
4. With the retaining tabs compressed, use a screwdriver in order to remove the pass-through connector through the inside of the transmission case.
5. Remove the wiring harness (11).

Installation Procedure





1. Connect the wiring harness assembly to these components:
2. The TFP switch assembly (13)
3. The pressure control solenoid (312) (red connector)

Important: The 1-2 shift solenoids wires are red and light green. The 2-3 shift solenoid wires are red and yellow.
4. The 1-2 shift solenoid (305) (white connector)

5. The 2-3 shift solenoids (305) (white connectors)
6. The TCC solenoid (335)
7. Install the control valve body.
8. Install the transmission side cover.