Removal

1. Disable the "SIR System. (Refer to "Disabling the SIR System".)
2. Remove air induction system.





3. Disconnect control cable assembly from control lever assembly.
4. Carefully press two retaining tabs and remove control cable assembly from converter housing.





5. Remove console. (Refer to "Console Removal.")
6. Place shifter in 2nd gear and disconnect control cable end from control base assembly lever.
7. Depress two tabs on control cable housing and remove control cable assembly from control base assembly.





8. Separate carpeting at front of dash under control cable assembly.

IMPORTANT: Carpet is held together by Velcro(R) tape.

9. Remove the retainers, on both sides of the cable pass-through opening, holding the sound deadening material.
10. Roll back the sound deadening material at the front of dash to gain access to the cable pass through grommet.





11. Place a large flat blade screwdriver against the driver's side of the cable pass through grommet as shown.
12. Push the grommet toward the passenger side of the vehicle and outward to disengage the grommet from the floor pan.

NOTICE: There is an extra retaining tab on the passenger side of the cable pass-through grommet. Removing the grommet passenger side first may cause damage to the floor pan.





CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED. TO HELP AVOID PERSONAL INJURY WHEN A VEHICLE IS ON A HOIST, PROVIDE ADDITIONAL SUPPORT FOR THE VEHICLE ON THE OPPOSITE END FROM WHICH COMPONENTS ARE BEING REMOVED.

13. Lift vehicle.
14. Remove the control cable and cable pass-through grommet from the outside of the vehicle.

IMPORTANT: When removing and installing control cables it is helpful to have a second person inside the vehicle to guide the cables and prevent them from being tangled.