ABS Mark 70 (ABS/ASR), Control Module and Hydraulic Unit, Installing

Control Module and Hydraulic Unit, Installing

• Do not remove sealing plugs at new hydraulic unit until the corresponding brake line is about to be installed.

• If the sealing plugs are removed too early, brake fluid can escape. If this occurs, unit may not be sufficiently filled or adequately bled.

• When installing, make sure that rubber installation pieces are not pressed out of bracket.

- Installation is performed in the reverse order of removal.

- Remove brake pedal actuator (V.A.G 1869/2).

- Bleed brake system, refer to => [ Brake System, Bleeding ] Brake System, Bleeding

- Enter radio code.

- Code the ABS control module (J104) with the in "Guided Fault Finding".