Lock Cylinder

Lock Cylinder


• Follow the procedure in the Repair Information when disconnecting and connecting the battery. Refer to => [ Disconnecting and Connecting Battery In Engine Compartment ] Disconnecting and Connecting Battery In Engine Compartment or => [ Disconnecting and Connecting Batteries In Luggage Compartment ] Disconnecting and Connecting Batteries In Luggage Compartment.

• Steering lock may be destroyed.

• If steering lock is operated without lock cylinder, it locks and must be replaced.

• Steering lock must not be operated without lock cylinder.

Removal

- Disconnect the battery. Refer to => [ Disconnecting and Connecting Battery In Engine Compartment ] Disconnecting and Connecting Battery In Engine Compartment or => [ Disconnecting and Connecting Batteries In Luggage Compartment ] Disconnecting and Connecting Batteries In Luggage Compartment.

- Remove the steering column trim.

• For reasons of clarity, the figure does not show the turn signal switch and windshield wiper switch. Switches must not be removed when removing lock cylinder.

• The immobilizer induction coil is attached to the lock cylinder and cannot be replaced separately.

- Insert ignition key into lock cylinder and turn it into position Drive.






Key positions of lock cylinder:

1 Position Off
2 Position Run
3 Position Start

• For reasons of clarity, the following illustration depicts lock cylinder as removed and without ignition key.






- Insert a steel wire (approximately 1.2 mm diameter) into the hole - arrow - next to the ignition key.

- Using the steel wire - 2 -, release - arrow - the retaining lever - 3 - of the lock cylinder - 1 -.

- Remove the lock cylinder - 1 - from the steering lock housing.

Installation

- Disconnect harness connector - arrow - at induction coil.






• To improve clarity, the ignition key is not shown in the following illustration.

- Insert the ignition key into the lock cylinder - 1 - and turn it to the Run position.






- Using the steel wire - 2 -, release - arrow - the retaining lever - 3 - of the lock cylinder - 1 -.

- Connect the immobilizer induction coil connector.

- Insert the lock cylinder - 1 - into the steering lock housing.

• Connection of induction coil for anti-theft immobilizer must be inserted into guide on steering lock housing.

- Pull the steel wire - 2 - out of the lock cylinder - 1 - and verify that the lock cylinder is securely seated in the steering lock housing.

- Install all components in reverse order of removal.