Window Regulator Basic Setting

Window Regulator Basic Setting

• Window regulator motor must operate with greatest possible operating force for window regulator basic setting. Therefore, it is necessary to leave the engine running.

• The window regulator basic setting is performed with door open but latch closed.

Procedure for window regulator basic setting:

• Start engine.

• Open door and close latch in door lock.

• Lower door window completely.

• Close door window and block with hand. Door window lowers (reverses).

• Close door window again within 5 seconds and block with hand again. The door window stops.

• Close door window again within 5 seconds. Door window runs without pinch protection up to mechanical window regulator stop.

• Within 5 seconds, hold window regulator switch for 5 seconds. Now window regulator motor is adjusted to window regulator.

• Open latch in door lock, door window lowers in short lift.

• Close door, door window closes.

The following 4 door window to roof pillar seal positions are possible:

• The door window runs into seal between markings. Door window adjustment is correct.

• Door window does not run up to upper marking. Door window must be corrected in height adjustment toward top. Refer to => [ Door Window, Adjusting Height to Roof Pillar Seal ] Door Window, Adjusting Height to Roof Pillar Seal

• Door window runs further into seal as far as lower marking. Door window must be corrected in height adjustment toward bottom. Refer to => [ Door Window, Adjusting Height to Roof Pillar Seal ] Door Window, Adjusting Height to Roof Pillar Seal

• Door window runs into seal and lowers again. Door window must be corrected in height adjustment toward bottom. Refer to => [ Door Window, Adjusting Height to Roof Pillar Seal ] Door Window, Adjusting Height to Roof Pillar Seal. Perform basic setting again after successful correction.