Tire Pressure Sensor: Service and Repair

Tire Pressure Sensor

Removing

- Remove the union nut - 1 -.





- Remove tire pressure sensor - 2 - from rim well.

Installing

CAUTION!
• Clean the valve opening before installing the tire pressure sensor.

- Insert the tire pressure sensor - 2 - with new seal and sealing washer and press it on the spots marked with the - arrows - into the disc wheel (rim).





- Press the tire pressure sensor - 2 - on the spots marked with the - arrows - into the disc wheel (rim).

Screw on union nut - 1 - from outside onto tire pressure sensor.

- Press the tire pressure sensor - 1 - on the spots marked with the - arrows - into the rim and tighten the union nut to 8 Nm.





CAUTION!
• Tighten the union nut to the tightening specification only.

• Sealing washer - 2 - becomes slightly deformed when doing this.

• The sealing washer can be installed one time only. At every installation, replace the sealing washer and rubber seal.

• Do not tighten the union nut again. This will damage the seal and it will leak.

Tightening Specifications