Compressor HVAC: Description and Operation

A/C Compressor, Installation Information

- Start the engine only after assembling the refrigerant circuit.

- After installing a new A/C compressor or fresh refrigerant oil has been filled into compressor (for example, after blowing through the A/C system), turn ribbed belt pulley of A/C compressor 10 rotations by hand before starting the engine. This prevents damage to the A/C compressor.

- Only start the engine when the refrigerant circuit is filled.

• The A/C compressor is always driven by the ribbed belt pulley (no A/C clutch).

• If the A/C compressor is blocked, the compressor shaft overload protection is activated. The blockage is mostly recognized by deformations/bumps on the ribbed belt pulley. In addition, the blockage can be recognized by the abraded rubber in the area of the ribbed belt pulley.

• The A/C compressor is equipped with a protected oil supply, this prevents A/C compressor damage in the event that the system is empty. This means that approximately 40 to 50 cm3 of refrigerant oil remains in the A/C compressor.

• The engine may only be started when the refrigerant circuit is installed correctly. For example; if the refrigerant lines are not connected to A/C compressor, when the engine is running the A/C compressor may heat up (via internal heat generation) so much that the A/C compressor will be damaged.

• A/C Compressor Regulator Valve (N280) is not activated when the refrigerant circuit is empty and the A/C compressor idles with the engine.

• If it is necessary to start the engine with a discharged refrigerant circuit:

• Refrigerant circuit must be fully assembled.

• At least 1/4 of the prescribed refrigerant oil must be in the A/C compressor.

• No not rev engine higher than 2000 rpm.

• The engine should only run as long as is absolutely necessary, maximum 10 minutes.

• Pay attention to the following when starting the engine for the first time after filling the refrigerant circuit:

- Start engine with A/C compressor switched off ("ECON" or AC ) and wait until the idling speed stabilizes.

- Open the instrument panel vents.

- Select the temperature setting "Lo" on the Front A/C display control head (E87).

- Turn on the A/C compressor ("AUTO") and let the engine run for 5 minutes at idling speed.