Transmission Position Sensor/Switch: Adjustments

Multifunction Transmission Range Switch, Adjusting

Special tools, testers and auxiliary items required

• Setting Gauge (T10173)

- Place the selector lever in the "N" position.

- Do not kink the selector lever cable.

Prerequisites

• Selector lever cable is disconnected from the selector shaft lever

• Shift rod is in the "N" position

• Bolts for the multifunction transmission range switch (F125) are loosened

• Lever/shift rod is removed

- Install the (T10173) onto the shift rod - 2 - and turn the multifunction switch - 1 - until the (T10173) engages on the connector tab of the multifunction switch.





- Tighten the (T10173) to the shift rod - 2 - using bolt - 3 -.

- Tighten the multifunction switch bolts - arrows - to 6 Nm.

- Remove the (T10173).

- Further installation is performed in the reverse sequence. Refer to => [ Installing ] Service and Repair.