Steering Column Electronic Systems Control Module, Valeo (J527), From 11.09

Steering Column Switch

Steering Column Electronic Systems Control Module (J527), Valeo, From 11.09

Removing:

CAUTION!
• Risk of airbag deployment!

• The airbag could deploy if the airbag unit is handled incorrectly.

• Observe safety precautions when working on the airbag.

CAUTION!
The removal and installation of individual steering column switch components must be done in the specified sequence, refer to => [ Steering Column Switch Components, Removal and Installation Sequence, From 11.09 ].

- Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

Remove the following components in order:

- Remove steering wheel.

- Remove steering column trim.





- Disconnect the connectors - 1 -, - 2 -, - 3 - and - 4 -, depending on the vehicle equipment level.

• Do not turn the spiral spring on the steering column electronic systems control module from its center position during removal. The front wheels must be in the straight-ahead position.

- Remove the 3 mounting bolts - arrows - and remove the steering column electronic systems control module from the steering column switch.

Installing:

CAUTION!
The turn signal switch lever could break when installing the control module.

The turn signal lever must be in the 0 position when installing the spiral spring so that it does not fall out.

Install in reverse order of removal, noting the following:

- Mount the steering column electronic systems control module on the steering column switch making sure it is straight.

- Install the three mounting bolts for the steering column electronic systems control module on the steering column switch module and tighten them to 1.5 Nm.

- Install all components in reverse order of removal.