Vehicle Electrical System Control Module, From 06.09

Vehicle Electrical System Control Module, From 06.09

• The relay carrier is clipped under the vehicle electrical system control module and can be removed.

• If the Vehicle electrical system control module (J519) is being replaced, then always perform the procedure to read out the code stored in the module. Refer to => [ Vehicle Electrical System Control Module (J519), From 06.09, Coding ] Vehicle Electrical System Control Module (J519), From 06.09, Coding.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

• The relay carrier under the vehicle electrical system control module is not installed in all vehicles. Depending on the vehicle equipment level, the vehicle may or may not have a relay carrier.

- Remove the relay carrier on the vehicle electrical system control module. Refer to => [ Relay Carrier On Vehicle Electrical System Control Module, From 06.09 ] Relay Carrier On Vehicle Electrical System Control Module, From 06.09.

- Disconnect the connectors.






- Press both locking mechanisms - arrows - and move the vehicle electrical system control module downward.

- Pull the vehicle electrical system control module out of the bracket downward and opposite the drive direction.

Installation

Install in reverse order of removal, noting the following:

- Install the vehicle electrical system control module into the bracket and then push on it until it audibly engages.