Power Distribution Module: Service and Repair

Vehicle Electrical System Control Module (J519)

• The relay carrier is clipped to the vehicle electrical system control module and can be removed.

• If the vehicle electrical system control module is being replaced, then always perform the procedure => [ Vehicle Electrical System Control Module (J519), Coding ] Testing and Inspection to read out the code stored in the module.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove the relay carrier on the vehicle electrical system control module. Refer to => [ Relay Carrier on Vehicle Electrical System Control Module (J519) ] Relay Carrier on Vehicle Electrical System Control Module (J519).

- Disconnect the connectors.






- Press both locking mechanisms - arrows - and move the vehicle electrical system control module downward.

- Pull the vehicle electrical system control module out of the bracket downward and opposite the drive direction.

Installation

Install in reverse order of removal, noting the following:

- Install the vehicle electrical system control module into the bracket and then push on it until it audibly engages.